the Behemoth was completed in the early part of 2015

This was a collaboration between a good friend and customer of mine Dan Warrington, who was at the time the bassist for Rise Of Avernus Dan had been in and out with different instruments over the years, and eventually we join forces on this Monster fretless bass. with the design based around a wrist injury which inhibited Dans wrist from bending correctly,  this meant that weight and balance was key and second only to the earth shaking tone.

Loaded with Series wound Nordstrand dual coils and a Delano MSE pre this bass has power but can also handle the warmest tones with ease.

$4975

  • 4 string Neck through.
  • Double cut.
  • 34″scale.
  • 19mm string spacing
  • Alder body wood.
  • Ebony fingerboard.
  • 3 piece neck Paduk, with maple core.
  • Nordstrand Dual coils with series, single coil, parallel switch on each.
  • Sonar 3 band Pre amp with mid selection.
  • Hipshot black hardware.
  • Hipshot Xtender key
  • Custom Acrylic ebony knobs by D-Cline design.
  • Flat black poly finish.
  • Schaller.
  • SKB hard case.

Technical Specifications

  • Input Impedance: >1 MOhm
  • Output Impedance: 100 Ohm
  • Signal-To-Noise Ratio: -98dB
  • Operating Voltage: +9v
  • Power Consumption: 0.8 mA
  • Bass: 40 Hz
  • Mid (Selectable): 300, 500 , 800 Hz

Control Configuration

  • Volume Active/Passive Push/Pull
  • Blend
  • Treble
  • Mid
  • Bass
  • Mid switch
  • x2 series single parallel

The Behemoths ergonomically designed outer curves are perfect for either seated or standing. the body has deep back cuts to contour to the player comfortably. A thin neck in combination with the Paduk and rock maple allows for fantastic resonance and solid sustain. The Behemoths neck is blended into the body to allow complete access to the full register of the fingerboard without hindrance.

Current build time for this bass is

12 – 18 months

Enquire